DMT Installation

Veriflite DMT consists of two sensors. The ORANGE sensor attaches directly to the trampoline bed, the BLUE sensor attaches to the landing area. It is essential that the sensors are located and oriented correctly, in the locations shown, to accurately detect bounces.

Place the Veriflite top plate at the edge of the Double Mini Trampoline bed, in line with the top of the red zone (between the mount and spotter zones):

The top plate legs fit through the bed. String beds may require some parting to fit the legs:

Remove the battery cover from the ORANGE sensor body by loosening the thumb screws until the cover lifts off. The thumb screws should remain attached to the battery cover.

Below the trampoline bed, fit the ORANGE sensor body to the top plate legs. The button must be towards the springs:

While holding the sensor body and top plate together, fasten four screws through the corners of the sensor body into the top plate:

Insert an AAA battery, observing the + and - markings on the plastics:

Press the sensor button and check the lights turn on:

Fit the battery cover so it sits over the sensor button and fasten using the thumb screws:

Remove the battery cover from the BLUE sensor body:

Insert an AAA battery, observing the + and - markings on the plastics:

Press the sensor button and check the lights turn on:

Fit the battery cover so it sits over the sensor button and fasten using the thumb screws:

Peel the red plastic covering from the adhesive pad:

Press firmly to stick the sensor to the edge of the DMT landing area:

Install the Veriflite DMT app from the Apple App Store or the Google Play Store.